VURA EnHanso

---

CHARACTERISTICS

- Very neutral colour & easy to spread
- Low VOC content
- Very low tendency to yellow
- High creeping strength due to gel-like consistency
- Easy dosing and mixing by use
- Weather-resistant bonding
- Good dimensional stability of the bonding layer
- Low tendency to fatigue
- Good adhesion on slightly humid stones
- Very low shrinkage during the hardening process and therefore low tensions in the bonding layer
- Very good alkali-stability, thus the adhesive is very well suited to bond concrete
- Excellently suited for bonding gas-impermeable materials as it is a solvent-free product

Usage Guide

MIXING & APPLICATION
Vura Oxi 7010is mainly used in the stone-working industry for the weather-resistant bonding and glueing of natural stone (marble, granite), Artificial stone or building materials (terrazzo, concrete).
The two parts ie. glue and hardener must be kept on the original cans/tins. Thoroughly clean and slightly roughen surfaces to be bonded. Thoroughly mix 2 parts (A+B) (by weight) of component A with 1 part (by weight) of component B until a homogeneous mix is achieved.
Avoid the use of plastic made of PVC, do use only plastic resistant to corrosive liquids. Take out from the two containers A and B the required amounts indicated in weight, of the two components. Mix very well the 2 parts A+B and proceed to use. During the mixing use clean tools. Ensure that the marble to be treated with the resin is completely dry and clean.
By means of the application of high- quality raw materials it was possible to develop a system which hardly yellows. Because of its gel-like consistency the product has a high creeping strength on vertical surfaces. It is nevertheless possible to attain thin adhesive joints. Other materials can also be glued with Oxi 7010, e.g. paper, wood, glass and many other materials.
we suggest to verify the ratio every time. To clean the tools, we suggest to use aromatic and light solvent, The hardening process is accelerated by heat and delayed by cold.