Drag Mouse Over The Image To Zoom View.
Description
VURA UnicolorTint
VURA Unicolor Tint is a coloring liquid tint in different color shades
CHARACTERISTICS
- Color matching of the adhesive to many common stone colors
- VURA Unicolor Tint can be used with different adhesives based on Epoxy, Polyester and PUR.
- High intensity pigment tint, easy adjustment of color shades
- Fluid consistency (of tint) makes it easier to mix with different consistency adhesives
- No fading – UV & light resistant tint
- Properties of the colored adhesives would remain same
Documents & Downloads
APPLICATION AREAS
VURA Unicolor Tint is used for coloring Oxi 7010, PoliFill-G, PoliMast, PoliMast-G and Vura Klear, also can be used for coloring Oxi 2010, Oxi 4010 and PoliFill-L. Thus, adhesive color can be matched as per stone color shade by adjusting the dosage of VURA Unicolor Tint.
Usage Guide
- Add max 5% of VURA Unicolor Tint to the adhesive to be colored, dosage is depending on
the color of the stone.
- Mix well to achieve homogenous color shade.
SPECIAL NOTES
- For professional use only.
- Use appropriate Gloves to protect your hands.
- First match the adhesive color with stone than only add the Hardener.
- For proper waste disposal, the container must be completely empty.
AVAILABLE COLORS
White, Black, Yellow Ochre, Beige, Grey, Green, Red
Drag Mouse Over The Image To Zoom View.
Description
VURA FiSeal Pro
VURA FiSeal Pro is a ready to use nano imregnating sealer providing advance protection against water, oil and other stains. The product is absorbed by the capillary forces of the stone and can therefore penetrate into the stone structure.
CHARACTERISTICS
- Fluoropolymer based product
- Nano impregnating technology
- Breathable
- Resistance to UV radiation
- The color of the stone is normally not enhanced (preliminary test)
- Enhance adhesion strength
- Reduction of water and dirt absorption during periods of moisture
- Maintenance of breathing properties because there is no surface layer
Usage Guide
Back and 4 sides of natural stone surfaces such as marble, granite, travertine, sandstone, limestone and absorbent material.
CLEANING
- Surface must be clean, dry and free from all waxes, layers/coatings
- It shall be taken into consideration that the stone contains no harmful salts (nitrates, sulphates, chlorides)
- The surface temperature should be between 10o to 35o C and sound
- Rinse well with water without fail after cleaning
- Before the stone is given its protective treatment, it must be totally dry. As a rule, this is the case after 1-2 days at the earliest
- Ensure that the area is well ventilated, and the surface is dry
PRE-TEST
Before starting the treatment, we recommend executing pre-tests, to examine the efficiency of the treatment, to evaluate the appearance of the treated surfaces (color enhancement) and to ascertain the material consumption as exactly as possible
Procedure of the treatment
- The best conditions for a treatment are an object- and surrounding temperature of 15o - 25°C and a protection from direct solar radiation and humidity exposure until the effectiveness of the protective effect
- In general, a single application is sufficient
- Apply the product with a brush, mop or an airless spraying equipment at low pressure (max. 1 bar over pressure) and a jet distance of 5-10 cm (condition: tubes and seals must be resistant to solvents)
- Approx. 20 minutes after application, respectively before the product has dried on the surface, any excess which has not been absorbed by the polished surface has to be completely removed with a suitable cloth so that no residue should remain on the polished surface
