---

CHARACTERISTICS

- C 1 T as per EN 12004
- Type 1 T as per IS 15477:2019
- For Ceramic and Vitrified Tiles
- Grouting on the wall only after 8 hour
- Application up to 10mm
- For floor & wall interior application
- Adjustable
- Excellent workability
- No vertical slip
- Economical & easy to use

---

Usage Guide

- VURA KrafTile is a tile adhesive certified as C 1 T (as per EN 12004) and Type 1T (according to IS 15477:2019) designed fortiles (>3% porosity).
Indooruse:
- On horizontal and vertical surfaces
- On Cement and cement-lime plaster, cement screeds, cement ground coats and concrete

SUBSTRATE PREPARATION
Adhesive can be applied on even and compact substrates, free of any substances that reduce adherence (grease, bitumen, oil, paint, dust etc.). Concrete should be at least 1 month old. Cement screeds and plasters should be fully cured. Anhydrite (residual moisture below 0.5%), gypsum (residual moisture below 1%) substrates should be mechanically roughened and cleaned from dust. Aerated concrete should be free form dust. Substrates must not be wet. Any existing dirt, loose layers and paint coating shall be mechanically removed. Absorbent substrates shall be dampen and remove excess water before application.

APPLICATION
Pour VURA FasTile + into a container with the precisely measured amount of clean water and stir with a drill and mixer until a homogeneous mass without lumps is obtained. Leave for 5 min. and then stir again. Apply the mortar with a suitable notched trowel. Use the proper sized notch trowel to ensure full bedding in the tile. Do not soak tiles in the water. The back buttering method shall be used for larger tiles and for outdoor applications (ie. additionally a thin layer of the mortar should be spread on the tile’s back side, contact area > 90%). Place the tiles only during the open time of the adhesive. Fresh excess mortar can be removed with water, hardened material can only be removed mechanically. Grouting on the wall can be done after 8 hrs in vitrified tiles and after 24 hrs in porous tiles using VURA grouts. Floors are set to light traffic after apprx. 24 hrs. Expansion joints, joints at the corners of walls and floor and around sanitary equipment shall be filled with sealants or shall be treated with appropriate treatment