VURA FiSeal Pro

VURA FiSeal Pro is a ready to use nano imregnating sealer providing advance protection against water, oil and other stains. The product is absorbed by the capillary forces of the stone and can therefore penetrate into the stone structure.

CHARACTERISTICS

- Fluoropolymer based product
- Nano impregnating technology
- Breathable
- Resistance to UV radiation
- The color of the stone is normally not enhanced (preliminary test)
- Enhance adhesion strength
- Reduction of water and dirt absorption during periods of moisture
- Maintenance of breathing properties because there is no surface layer

Usage Guide

Back and 4 sides of natural stone surfaces such as marble, granite, travertine, sandstone, limestone and absorbent material.

CLEANING
- Surface must be clean, dry and free from all waxes, layers/coatings
- It shall be taken into consideration that the stone contains no harmful salts (nitrates, sulphates, chlorides)
- The surface temperature should be between 10o to 35o C and sound
- Rinse well with water without fail after cleaning
- Before the stone is given its protective treatment, it must be totally dry. As a rule, this is the case after 1-2 days at the earliest
- Ensure that the area is well ventilated, and the surface is dry

PRE-TEST
Before starting the treatment, we recommend executing pre-tests, to examine the efficiency of the treatment, to evaluate the appearance of the treated surfaces (color enhancement) and to ascertain the material consumption as exactly as possible

Procedure of the treatment
- The best conditions for a treatment are an object- and surrounding temperature of 15o - 25°C and a protection from direct solar radiation and humidity exposure until the effectiveness of the protective effect
- In general, a single application is sufficient
- Apply the product with a brush, mop or an airless spraying equipment at low pressure (max. 1 bar over pressure) and a jet distance of 5-10 cm (condition: tubes and seals must be resistant to solvents)
- Approx. 20 minutes after application, respectively before the product has dried on the surface, any excess which has not been absorbed by the polished surface has to be completely removed with a suitable cloth so that no residue should remain on the polished surface