VURA DenStone800

VURA DenStone 800 is a penetrating impregnating hardener with lithium treatment for natural stone, marble, terrazzo and polished concrete surfaces which has been ground and polished upto 800 grits. This reduces alkalinity (efflorescence), improves adhesion and reducing dusting. Used during the production (grinding and polishing) of marbles, natural stones, concrete or terrazzo surfaces. VURA DenStone 800 is designed to enhance the process, making it easier to reprofile as well as reduce costly wear and damage to diamond abrasives.

CHARACTERISTICS

- Penetrates and seals new and existing marble, natural stones, terrazzo and concrete
- Improves chemical and water resistance
- Deepens clarity and heightens gloss
- Increase abrasion resistance
- Reduces alkalinity / efflorescence
- Easy to use and maintain
- Interior and exterior use
- User friendly, non-whitening
- Environmentally friendly, water based formula
- VOC compliant

Usage Guide

For the treatment of polished absorbent marble and natural stone e.g. slate, marble, limestone, sandstone, granite, travertine etc.

SURFACE PREPARATION
- Clean the surface to remove any dirt, laitance, curing compound
- Surface should be sound, clean and free of waxes, dirt and coatings
- Apply only when temperatures will be above 2o C for atleast 4 hrs. following application
- Do not use citrus or acidic cleaners

APPLICATION
- VURA DenStone 800 may be applied immediately after 800 grit polish is over
- Spray VURA DenStone 800 evenly on the surface. Spread out any pools with a soft bristle broom or a flat microfiber pad
- Keep surface wet for atleast 20 minutes, adding more material where needed in order to maintain a uniformly wet surface
- After material has penetrated and is no longer wet on the surface, continue grinding and polishing to the intended final surface profile and desired finish